Microstructural and wear properties of the Al-B4C composite coating produced by hot-press sintering on AA-2024 alloy

Basit Öğe Kaydı
dc.contributor.authorOzay, C.
dc.contributor.authorBallikaya, H.
dc.contributor.authorDagdelen, F.
dc.contributor.authorKarlidag, O. E.
dc.date.accessioned2026-08-12T17:19:42Z
dc.date.issued2021
dc.departmentFırat Üniversitesi
dc.description.abstractIn this study, the surface of an AA-2024 alloy was covered with reinforced composite coating using hotpress sintering method. Al and B4C powders were synthesized through mechanical alloying technique and coated on the AA-2024 substrate at different rates. The microstructure of the intermediate transition region formed between the substrate (AA-2024 Al alloy) and the coating layer (Al/B4C MMCs), the microstructure of the Al/B4C metal matrix composites (MMCs) coating, the microhardness, and the adhesive wear resistance of the Al/B4C MMCs coating layer were investigated. It was observed that B4C powders homogeneously dispersed in the microstructure of the Al/B4C MMCs coating layer, moreover, the Al matrix and B4C reinforcement particles were bonded without a gap. It was also determined that an interface bonding occurred between Al/B4C MMCs coating layer and the AA-2024 substrate. Accordingly, it was determined that with the increase of B4C reinforcement particle ratio, the hardness of the coating layer, and the wear resistance increased.
dc.description.sponsorshipScientific Research Project Coordination Unit of Firat University Rectorate [19.08]
dc.description.sponsorshipThis study was funded by the Scientific Research Project Coordination Unit of Firat University Rectorate within the scope of Project No: TEKF. 19.08.
dc.identifier.doi10.1007/s12206-021-0613-1
dc.identifier.endpage2901
dc.identifier.issn1738-494X
dc.identifier.issn1976-3824
dc.identifier.issue7
dc.identifier.orcid0000-0001-9958-519X
dc.identifier.orcid0000-0001-9849-590X
dc.identifier.orcid0000-0001-5484-0214
dc.identifier.scopus2-s2.0-85109046630
dc.identifier.scopusqualityQ2
dc.identifier.startpage2895
dc.identifier.urihttps://doi.org/10.1007/s12206-021-0613-1
dc.identifier.urihttps://hdl.handle.net/11508/53280
dc.identifier.volume35
dc.identifier.wosWOS:000668090100009
dc.identifier.wosqualityQ3
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.language.isoen
dc.publisherKorean Soc Mechanical Engineers
dc.relation.ispartofJournal of Mechanical Science and Technology
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/closedAccess
dc.snmzKA_WoS_20260511
dc.subjectHot press sintering
dc.subjectAl-B4C coating
dc.subjectWear
dc.subjectMMCs
dc.titleMicrostructural and wear properties of the Al-B4C composite coating produced by hot-press sintering on AA-2024 alloy
dc.typeArticle

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu