APPLICATION OF THE TAGUCHI METHOD TO SELECT THE OPTIMUM CUTTING PARAMETERS FOR TANGENTIAL CYLINDRICAL GRINDING OF AISI D3 TOOL STEEL

Basit Öğe Kaydı
dc.contributor.authorOzay, Cetin
dc.contributor.authorBallikaya, Hasan
dc.contributor.authorSavas, Vedat
dc.date.accessioned2026-08-12T17:04:30Z
dc.date.issued2016
dc.departmentFırat Üniversitesi
dc.description.abstractThe purpose of this research was an analysis of the optimum cutting conditions for the lowest surface roughness in tangential cylindrical grinding of the AISI D3 tool steel using the Taguchi method. In this experimental investigation, the surface roughness with various wheel speeds, workpiece speeds, feed rates and depths was observed. The surface roughness was investigated employing the Taguchi design of experiments and an analysis of variance (ANOVA). Significant machining parameters were identified using the signal-to-noise ratio. The results of the experiments indicate that the wheel speed and feed rate have dominating effects on the surface roughness during the cutting. The developed new grinding process can be used in the machining industries in order to determine the optimum cutting parameters for the minimum surface roughness.
dc.description.sponsorshipFirat University, Turkey [FUBAP-TEF.11.06]
dc.description.sponsorshipThe authors would like to acknowledge the Firat University, Turkey, for the financial support (Project No. FUBAP-TEF.11.06).
dc.identifier.doi10.17222/mit.2014.293
dc.identifier.endpage87
dc.identifier.issn1580-2949
dc.identifier.issn1580-3414
dc.identifier.issue1
dc.identifier.orcid0000-0001-9958-519X
dc.identifier.orcid0000-0001-5484-0214
dc.identifier.scopus2-s2.0-84958214775
dc.identifier.scopusqualityQ3
dc.identifier.startpage81
dc.identifier.urihttps://doi.org/10.17222/mit.2014.293
dc.identifier.urihttps://hdl.handle.net/11508/48746
dc.identifier.volume50
dc.identifier.wosWOS:000370993000014
dc.identifier.wosqualityQ4
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.language.isoen
dc.publisherInst Za Kovinske Materiale I in Tehnologie
dc.relation.ispartofMateriali in Tehnologije
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanı
dc.rightsinfo:eu-repo/semantics/openAccess
dc.snmzKA_WoS_20260511
dc.subjecttangential cylindrical grinding
dc.subjectTaguchi method
dc.subjectsurface roughness
dc.subjectANOVA
dc.titleAPPLICATION OF THE TAGUCHI METHOD TO SELECT THE OPTIMUM CUTTING PARAMETERS FOR TANGENTIAL CYLINDRICAL GRINDING OF AISI D3 TOOL STEEL
dc.typeArticle

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu